Initial Operation; Commissioning; Basic Settings; A) Select Device Id - VOLTCRAFT Energy Logger 4000 Bedienungsanleitung

Initial Operation

Do not exceed the maximum permitted input values.
Before measuring, check the measuring device for damage such as cuts, cracks
or squeezing. A defective device must not be used. Mortal danger!
Before using for the first time, the enclosed buffer battery be inserted for the time and date. Inserting and
changing the battery can be found in Section „Maintenance and Cleaning".
After inserting the buffer battery, connect the measuring device in a standard protection socket. The
measuring device is ready for programming or operation.

Basic settings

After the first use, some parameters must be preset to allow a correct display. You can reach this mode by
pressing the „MODE" and „Continue" keys (7) for at least 2 seconds simultaneously. You now reach the
„Select device ID" menu item.
a) Select ID device
This equipment ID number allows you to administer up to 10 electrical users on one meter unit. In the
adjustment mode the ID number blinks in the right upper display. Choose the desired identification num-
ber (ID 0-9 with the buttons "min" (3) and "max" (4) and confirm your choice with the button "MODE" (5).
The machine will then send you automatically to the next mode, "time setting."
b) Time settings
First you select the the desired time format (12/24-h system) with the two arrow keys (3 and 4) and con-
firm your selection with the „MODE" key (5).
Select the date format with the two arrow keys (3 and 4). Available are:
dd.mm.yyyy
mm.dd.yyyy
Confirm the selection by pressing the "MODE" (5) key. You will automatically reach the next mode.
The hours display of the time flashes. Set the correct time with the arrow keys (3 and 4). After entering
the hours, you reach the minute input by pressing the „Continue" arrow key (7). Repeat these steps until
you have set day, month and year.
Confirm your settings in the year mode by pressing the "MODE" (5) key. The time starts to run and you
automatically reach the next mode.
28
for day/month and year or
for month/day and year