VOLTCRAFT KBM-700 Bedienungsanleitung Seite 35

6. In "COND", "TDS" and "Salt" modes, the unit is selected automatically: µS/cm, mS/cm,
ppm or ppt.
7. If the measured value is outside of the measurement range, "----" will appear on the LCD
display (8).
Do not touch or wipe the surface of the inner black plate on the conductivity cell.
The automatic temperature compensation (ATC) ensures precise measurements
when there are different liquid temperatures.
8. After you have finished taking measurements, clean the measurement probe with distilled
water and replace the soaking bottle.
Displaying maximum/minimum values
1
1. The meter can display the maximum and minimum values of a measurement.
2. Press and hold the
the LCD display (8).
3. Press the
4. Press and hold the
symbols will disappear from the LCD display.
Please note that the automatic power-off function will not work when the device is in
MAX/MIN mode.
Switching units
2
1. Press and hold the
units °C and °F.
2. For redox measurements (ORP mode), you can switch between "ORP-mV" and "pH-mV".
Storing and recalling measured values
3
1. Press the
stored value will appear on the LCD display (8).
2. Press and hold the
3. Press the
4. To erase all stored values, press and hold the
approx. 3 seconds.
button (4) until "MAX" (F) and "MIN" (F) flash simultaneously on
button briefly to switch between the maximum and minimum values.
button to exit the max/min display. The "MAX" (F) and "MIN" (F)
button (3) for approx. 3 seconds to switch between the temperature
button (2) to store a measured value. The "STORE" symbol (L) and the
button for approx. 3 seconds to recall the stored values.
(5) and (6) buttons to scroll through the stored values.
and buttons simultaneously for
35