H) Storing And Recalling Measured Values; Advanced Settings; Ending Operation - VOLTCRAFT DO-600 Bedienungsanleitung

h) Storing and recalling measured values

1. Press the button (2) to store a measured value. The "STORE" symbol and the stored
value are displayed on the LC display (8).
2. Press and hold the
3. Press the
4. To erase all stored values, press and hold the
for approx. 3 seconds.
5. Press and hold the
i) Advanced settings
1. Use the button (3) to enter "DO" operating mode.
2. Press and hold the
enter advanced settings.
3. Press the
4. Select the compensation value by pressing either the
range from 0 to 50 ppt. Confirm the setting with the
5. Press and hold the
button (4) to select altitude compensation. Select the compensation value by pressing
either the
with the button.
6. Press and hold the
to reset the meter to its factory settings, press the
j) Ending operation
• The probe electrodes must be kept moist after completing the measurement.
• If necessary, top up the electrolyte in the membrane cap as outlined in Section "c) Initial
commissioning".
• Cover the measuring probe with the protective probe cap after use. The sponge must be
moistened slightly with distilled water or very clean drinking water; never soak it!
button for approx. 3 seconds to recall the stored values.
button (5) and
button to leave storage mode and return to measuring mode.
button (5) and
button (2) to select salt compensation.
button (5) and
button or the button in a range from 0 to 20000 ft. Confirm the setting
button (5) and
button (6) to scroll through the stored values.
button (5) and
button (6) together for approx. 3 seconds to
button (6) for approx. 3 seconds. Press the
button (6) for approx. 3 seconds again. In order
button (6) together
button or the
button (3).
button (7).
button in a
29