Switching On/Off; Connection And Preparation - VOLTCRAFT KBM-700 Bedienungsanleitung

1. In memory recall, you can use these buttons to move through the stored
measurements.
2. Press and hold these buttons simultaneously for approx. 3 seconds to
switch to advanced settings (see section "i) Advanced settings").
1. Press this button to select the operating mode.
2. Press and hold this button for approx. 3 seconds to switch between the
temperature units °C and °F. In ORP mode, switch between "ORP-mV" and
"ph-mV".
1. Press this button to switch the meter on or off.
2. Press and hold this button for approx. 3 seconds to start calibration.
e) Switching on/off
• Briefly press the "
• When you switch it on, all elements will appear on the LCD display (8) for a few seconds.
Depending on the measuring probe used, a measurement and the temperature will subse-
quently be displayed.
• The battery status indicator (M) in the lower-left corner of the display indicates the current
status of the inserted battery. If the indicator is flashing, the battery is flat and must be
replaced. For details on how to replace the battery, see section "a) Inserting/changing the
batteries".
• The meter switches off automatically after approximately 10 minutes of inactivity.
f) Connection and preparation
Without additional accessories, the meter with item no. 1763394 can only measure
the pH value and the temperature It does not comes with a conductivity cell or redox
probe. These may be purchased separately.
• Connect the required measuring probes to the corresponding inputs. (the conductivity cell
to the conductivity cell input (13), the pH electrode and the redox probe to the pH/ORP
electrode input (14))
" button (7) to switch the meter on or off.
31