D) Setting Up The Meter/Mounting To A Tripod; E) Switching On And Off; Setting Variable; A) Available Settings In The Overview - VOLTCRAFT 2149778 Bedienungsanleitung

d) Setting up the meter/mounting to a tripod

The meter can be secured to a tripod (included with the product) via the tripod socket (10) on the rear of the device.
This enables sound level measurements to be taken without being influenced by noise from the user.

e) Switching on and off

• Briefly press the on/off button
tion phase (display and system test), the measuring device will be ready to use.
• Press the on/off button
• The meter will save the last setting and display it when the meter restarts.

9. Setting variable

a) Available settings in the overview

Change and save the setting options for the respective measurement to the memory.
Setting
Temperature unit
Light intensity unit
Sound level unit
Offset
Wind speed unit
Unit of the air flow rate
Unit of area
Size of the area
Automatic power-off

b) Changing the unit settings

• Press and hold the
the LCD display (7) to indicate that settings mode is enabled. The "Unit" symbol will appear on the LCD display.
• Press the (13) or
• Press the button (15) to confirm your selection. The current unit will be displayed.
• Press the (13) or
• Press the button (15) to confirm and save the new setting.
• When you have finished changing the settings, press and hold the
exit settings mode.
(1) to switch on the meter. All display elements will appear. After a short initialisa-
(1) to turn the meter off. The display will turn off and the meter will switch off.
Menu icon
TEMP
LIGHT
SOUND
Type KJ
VEL
FLOW
AREA
AREA
SLP
button (2) for approximately 2 seconds to access settings mode. "SETUP" will appear on
(14) button to select the measurement mode for the unit that you want to change.
(14) button to change the unit to one of the available options.
Setting variable
°C or °F
LUX or FC
dBA or dBC
Temperature offset
Knots m/s Mph, ft/min km/h
ft3/min, m3/min
in c, cm , ft
2 2 2
The cross-section used as the measuring surface
On or off
button (2) for approximately 2 seconds to
35