NOTE
►
Do not exceed the maximal viscosity of the
appliance . The spray material must not be
too thick . Otherwise, the appliance might
clog .
►
Ensure that the spray material and thinning
agent are compatible . Using an unsuitable
thinning agent may cause clots that clog the
appliance . Never mix synthetic resin varnish-
es with cellulose thinners .
►
To find out which thinning agent is suitable
for your spray material (water, paint thinner),
refer to the manufacturer's notes provided
with the spray material .
►
Granular products and products containing
solids must not be sprayed . Their abrasive
effect will shorten the service life of the pump
and valve .
Preparing the surface
♦
Carefully cover a large area around the spray
surface . Any surface that is not masked could
become contaminated .
♦
Ensure that the surface is clean, dry and free of
grease .
♦
Polished surfaces should be lightly sanded and
the sanding dust removed .
■
6
│
GB │ IE │ NI │ CY
Setting up
Assembly/disassembly
♦
Move the ▸ mark on the spray unit
mark on the motor unit . Now, turn the spray
unit
until the ▸ mark on the spray unit
locks into the
mark on the motor unit
♦
Unlock the lock
. Turn the ▸ mark on the
5a
spray unit
to the
to separate the two units .
Choosing/changing the nozzle
Nozzle
1 .8 mm nozzle
2 .6 mm nozzle
♦
Undo the union nut
from the spray unit
♦
Fit the desired nozzle
♦
Screw the union nut
unit
.
Adding spray material
♦
Unscrew the paint cup
unit
.
♦
To work on a horizontal object, place the riser
pipe
in front, facing the nozzle head
work overhead, place the riser pipe
back, facing the motor unit
♦
Fill the paint cup
screw it firmly onto the spray unit
Switching the appliance on/off
Working methods:
♦
Hold the spray gun at a constant distance
from the object . The ideal spraying distance is
approx . 15 cm .
♦
Work out the best settings by carrying out a test .
♦
Do not switch the appliance on/off over the
spray surface . Rather, start/end the spraying
process approx . 10 cm from the spray surface .
to the
mark on the motor unit
Use
all types of paints and
lacquers
viscous spray material
completely and remove it
.
onto the nozzle head
back onto the spray
from the spray
in the
.
with the spray material and
.
PFS 400 A1
.
. To