Preparations For Use; Connecting The Airbrush Set; Mixing Paints For Use; Turning Airbrush Compressor On / Off - Parkside PABK 60 B2 Bedienungs- Und Sicherheitshinweise

Preparations for use

Preparations for use
Warning: This appliance can slide on smooth sur-
faces during normal use. This can be prevented by
applying light pressure to the appliance.
Clean dusty surfaces so that the suction cups can grip
well. Otherwise a slight shift in position is possible.

Connecting the airbrush set

Be absolutely certain to disconnect the mains
plug before connecting the airbrush set to the
compressor and release the pressure in the lines
by actuating the vent of the air blow gun
Use the respective screw connection to connect
the spray stylus
3
the coiled hose to the airbrush connection
Use the included open-end wrench.
Fasten the paint mixing beaker with connection
lid to the spray stylus
5
Insert the mains plug into the mains socket.
Note: For optimal results, professionals connect
an intermediate pressure reducer (not included
with delivery). The pressure reducer can be used
to adjust the compressed air at the spray gun
and optimise it to your needs.

Mixing paints for use

The paints included are water-soluble. In order to
properly apply the paints, add water and stir. As
delivered, the paints are too viscous.
First fill the beaker with your selected paint
colour with water.
Now screw the cover back on the beaker and
shake it.
Now remove two full droppers (1.5 mark on
the dropper) and fill these into a mixed glass
filled half way with water.
Shake the beaker. Now your paint has reached
the correct consistency.
Attach the paint mixing glass
to Ill. B.
10 GB
9
with the coiled hose
2
(see Ill. A).
13
(see Ill. B).
3
according
5
Note: If desired, you can adjust the amount of
water added to influence the colour intensity
yourself as with a watercolour box. The more
water you add, the „thinner" the colour.
You can also mix individualised colour tones
from the available colour pastes. Please take
note, there must be no paint clumps remaining
in the paint containers. The consistency should
correspond to that of water.
Note: If the paint used does not cover well, in-
crease the amount of paint in the mixture ratio.
Turning airbrush compressor
on / off
.
and Turn the airbrush compressor
. on / off switch
1
Turn the airbrush compressor
the on / off switch
Ill. C).
Note: Full pressure is built up after two seconds.

Regulating the air pressure

Regulate the air pressure by actuating the vent
of the air blow gun
extent.
The air pressure can be adjusted by turning the
air pressure regulator
The air gauge shows the pressure level.
Turning the air pressure regulator
reduces the air pressure, turning the air pres-
sure regulator
pressure.
An internal valve bleeds overpressure if it is not
reduced.

Regulating the spraying results

Regulate the amount of the paint supplied by
turning the paint nozzle of the spray stylus to
the right or left (see Ill. B).
on by setting the
1
to the position "I" (see Ill. C).
14
off by setting
1
in the position "0" (see
14
to more or less of an
9
.
15
to the left
15
to the right increases the air
15