Spraying Tools; Functioning - Dibo ECN-S Bedienungsanleitung

4.3. Spraying tools

The High pressure spray gun has been carried out with a grey handle.
Not spraying: release the lever in the handle.
Spraying: pressing the lever in the handle.
Spray security: slap the block-system out in the lever.
The machine is standard provided with a double spray lance and has two spray pipes.
Halfway the spray lance there is a handle present which is rotatable.
Turn the handle to the right: closed. This is the spray jet with highest possible adjustable pressure.
There will be no sucking in of the chemical products.
Turn the handle to the left: opening. Spray jet with reduced pressure. Second jet with low pressure.
When the pressure reduces, the more chemicals will be sucked in.
Couple the high pressure hose against the high pressure coupling and tighten. Couple the high pressure
spray gun (at the other side of high pressure hose) against the lance and tighten these (see photo's below).

4.4. Functioning

Store the high pressure cleaner, as possible, in a horizontally position.
Connect the spray gun with the high pressure hose (without spray lance) to the high pressure cleaner.
Connect the high pressure cleaner electrically (plug in socket).
Turn the operating switch to position 1=ON.
Aim the spray gun into the free space and operate the spray gun until the water jet is completely de aerated (+-
30 sec.). Turn the operating switch to position 0=OFF. Connect the spray lance to the spray gun.
Turn the operating switch to position 1=ON.
Operate the spray gun and check the working pressure on the pressure gauge.
Adjust if necessary the pressure regulator for the right working pressure.
ECN-S REV 0
Block-system
DiBO n.v. 42