HBM U5 serie Montageanleitung Seite 20

Electrical connection
S Cable with sub‐D male connector
Top view
Fig. 8.4 Sub‐D male connector assignment
The cable shielding is connected in accordance with the Greenline concept.
This means that the measurement system is surrounded by a Faraday cage
and is not affected by electromagnetic interference.
Connectors to CE standard are to be fitted at the free cable end of the
transducer. The shielding is here to be laid over the whole area. If a different
connection technique is used then good EMC shielding is to be provided in the
wiring loom, the shielding again being laid over the full area (see also HBM
Greenline Information, document G36.35.0).
18
Sub‐D
connector pin
1
2
3
4
13
12
A00809_08_Y00_01 HBM: public
Order code: D or F
Assignment
Measurement signal (+)
Excitation voltage (-)
Excitation voltage (+)
Measurement signal (-)
Sensor circuit (+)
Sensor circuit (-)
Wire
colour
WH
BK
BU
RD
GN
GY
U5