Herunterladen Inhalt Inhalt Diese Seite drucken

Changing Water Filter; Care And Descaling - Coffeemaxx Z 01113 Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

EN

Changing Water Filter

To produce a more aromatic coffee fl avour, the device has a water fi lter which is inser-
ted in the water reservoir. If the
display, the water fi lter should be replaced. You can order new water fi lters in our online
shop (see the "Ordering Replacement Parts" chapter).
1. Open the water reservoir cover and pull out the water fi lter by its bracket.
5. To delete the
the 2–12 Tassen button simultaneously.
The absence of a water fi lter does not stop the device from working properly.

Care and Descaling

PLEASE NOTE!
The hotplate is very hot after use! Let it cool down fi rst before cleaning it.
Never immerse the device, the cable or the plug in water.
Do not use corrosive or abrasive cleaning agents to clean the device. These could
damage the surface.
1. Clean the coffee mill using the cleaning brush.
3. Then close the cover again by pressing down on the cover and adjusting the screw on
the opening for cleaning the coffee mill with the shaft end of the cleaning brush to the
"Closed" symbol
4. Then press the unlocking button on the side of the device and open the fi lter com-
partment.
5. Take out the permanent fi lter and dispose of the coffee powder.
6. Clean the permanent fi lter and the fi lter compartment insert with hot water and a little
detergent if necessary.
7. Then dry all parts thoroughly and place them in the coffee machine again.
01113_DE-GB-FR-NL_V11.indb 24
01113_DE-GB-FR-NL_V11.indb 24
24
symbol and the word "FILTER" are shown on the
2. Open the lower part of the water fi lter bracket, take out the
water fi lter and dispose of it.
3. Insert a new water fi lter and then close the water fi lter
bracket again.
4. Place the water fi lter bracket back into the wa-
ter reservoir. Make sure that the water fi lter is sea-
ted correctly in the slot in the water reservoir.
symbol on the display, press the Kaffeestärke button and
2. Adjust the screw at the opening for cleaning the cof-
fee mill with the shaft end of the cleaning brush to the
"Open" symbol . The cover will open up and you can then
remove any excess coffee powder with the cleaning brush.
.
10.02.2016 10:53:17
10.02.2016 10:53:17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis