Descaling Program; Preperation; Phase 1 - Descaling; Phase 2 - Rinsing - Princess CAFFÈ ITALIANO Anleitung

Descaling with citric acid is too slow. That is why a proper descaling cannot be guaranteed.
The warranty does not cover damage resulting from the use of an unsuitable descaler or non-compliance
with the descaling specifications.
Please be careful when handling the decalcifying agent to prevent damage to furniture or clothing.
Please for that reason use cups that are as tall as possible and place them under the respective dispensers
in such a way as to prevent splatters.

Descaling program

Your Caffè Italiano includes an automatic descaling program that lasts approximately for 25 to 30 minutes.
The program has 2 phases:
phase 1 = descaling
phase 2 = rinsing
The first phase consists of 3 descaling cycles, one for each function. In the following second phase the
descaling agent is rinsed out with tap water through 7 consecutive passes. Note: Once the automatic descaling
program has started, it cannot be interrupted. In an emergency you can pull out the power supply plug.
Preparation
1. Unscrew the red steam nozzle (23) from the steam outlet (22). Use the Allen key (31) for this - it is
located on the bottom of the drip pan (8).
2. Remove the anti-chlorine filter (17) from the water reservoir (4).
3. Fill one portion (125 ml) of descaler into the empty water reservoir (4), place the red steam nozzle (23)
in it and put the reservoir back into the appliance.
4. Push the empty pad cartridge (6) into the appliance and move the rocking lever (5) to .
5. Place a large mug (contents at least 250 ml) under the hot water outlet (7).

Phase 1 - Descaling

Phase 1 is carried out 3 times:
1. Once for the "hot water function" position
2. Once for the "coffee function" position
3. Once for the "steam function" position
1. Descaling "hot water function"
Switch the appliance on using the on/off button
and 12) (3 to 4 seconds) until the pump briefly starts running. The on/off button
illuminated in yellow as long as the descaling program is running. The pump runs three times per minute,
each time for one second.
2. Descaling "coffee function"
Approximately 5 minutes after the "hot water descaling" the start/stop button
the liquid that has run into the mug back into the water reservoir (4), place the mug under the steam outlet
(22), push the rocking lever (5) to
3. Descaling "steam function"
Approximately 5 minutes after the "coffee descaling function" the start/stop button
again. Shake the liquid that has run into the mug back into the water reservoir, place the mug under the
steam outlet (22), and press the start/stop button
After another 5 minutes the first phase of the descaling program is completed. The
start/stop button (12) flashes red again.

Phase 2 - Rinsing

1. Rinse out the water reservoir (4) and return it to the appliance filled with tap water up
to the max mark. Place the mug under the outlet (3), push the rocking lever (5) to
and press the green flashing start/stop button
2. As soon as the start/stop button
hot water outlet (7), push the rocking lever (5) to
start/stop button
and press the start/stop button
(12) flashes green again, place the mug under the
.
(10) and then simultaneously press both buttons (10
(12).
(12) again.
(12).
and press the green flashing
(10) is continuously
(12) flashes red. Shake
(12) flashes red
23