Device Settings - Carl Valentin Spectra 107/12 Kurzanleitung Und Hinweise Zur Produktsicherheit

Key:
Key:
Key:
Key:
Key:

Device Settings

Keys: , ,
Key:
Key:
Key:
Key:
Label error length: Value range: 1 mm ... 999 mm.
Synchronization:
On: If a label is missed on the liner an error message is displayed.
Off: Missing labels are ignored, i.e. it is printed into the gap.
Flip label:
The axis of reflection is in the middle of the label. If the label width was not transferred to the
printer, automatically the default label width i.e. the width of the printhead is used. It is
recommended to use labels with the same width as the printhead. Otherwise this can cause
problems in positioning. Because of this reason it is recommended using labels with the same
width as the printhead. Otherwise this can cause problems in positioning.
Rotate label:
According to standard the label is printed ahead with a rotation of 0°. If the function is activated,
the label is rotated by 180° and printed in reading direction.
Alignment:
The adjustment of label is effected only after 'flip/rotate label', i.e. the adjustment is
independent of the functions flip and rotate label.
Left: The label is aligned at the left-most position of printhead.
Centre: The label is aligned at central point of printhead.
Right: The label is aligned at right-most position of printhead.
Measure label automatically:
On: After switching on the printer, the loaded label is automatically measured.
Off: In order to start the measurement procedure you have to change to the corresponding
menu.
Field handling:
Off: The complete print memory is deleted.
Keep graphic: A graphic res. a TrueType font is transferred to the printer once and stored in
the printer internal memory. For the following print order only the modified data is transferred to
the printer. The advantage is the saving of transmitting time for the graphic data.
The graphic data created by the printer itself (internal fonts, bar codes, ...) is generated only if
they were changed. The generating time is saved.
Delete graphic: The graphics res. TrueType fonts stored in the printer-internal memory is
deleted but the other fields are kept.
Codepage:
Indication of the font used in the printer.
External parameters:
Label dimension only: The parameters for label length, gap length and label width can be
transferred to the printer. All other parameter settings are to be made directly at the printer.
On: Sending parameters such as print speed and contrast via our label creation software to
the printer. Parameters which are set directly at the printer before are no longer considered.
Off: Only settings made directly at the printer are considered.
Buzzer:
On: An acoustic signal is audible when pressing a key.
Value range: 1 ... 7.
Off: No signal is audible.
Display:
Setting of display contrast.
Value range: 0 ... 7.
English
Spectra
89