Unpack The Label Printer; Scope Of Delivery; Set Up The Label Printer; Connect The Label Printer - Carl Valentin Spectra 107/12 Kurzanleitung Und Hinweise Zur Produktsicherheit

Spectra

Unpack the Label Printer


Lift the label printer out of the box.

Check the label printer for transport damages.

Check delivery for completeness.

Scope of Delivery

•
Label printer.
•
Empty core, mounted on the transfer ribbon rewinder.
•
Tear-off edge (basic printers only).
NOTICE!
Retain the original packaging for subsequent transport.

Set up the Label Printer

CAUTION!
The label printer and the print media can be damaged by moisture and water.

Set up the label printer only in a dry place protected from sprayed water.

Set up the label printer on a level, vibration-free and air draught-free surface.

Open the cover of label printer.

Remove the foam transportation safeguards near the printhead.

Connect the Label Printer

The label printer is equipped with a versatile power supply unit. The device may be operated with a mains voltage of 230 V AC /
50 ... 60 Hz without any adjustments or modifications.
CAUTION!
The label printer can be damaged by undefined switch-on currents.

Set the power switch to 'O' before plugging in the label printer.

Insert the power cable into the power connection socket.

Insert the plug of power cable into a grounded electrical outlet.
NOTICE!
Insufficient or missing grounding can cause faults during operation.
Ensure that all computers and connection cables connected to the label printer are grounded.

Connect the label printer to a computer or network with a suitable cable.

Initial Operation of the Label Printer


After all connections are completed, switch on the label printer.
The main menu appears which shows the printer type, current date and time.

Insert the label material and transfer ribbon.

Start measuring in the menu 'Label layout/Measure label'.

Press the key to finish measuring.
NOTICE!
To enable a correct measuring, at least two complete labels have to be passed through (not for continuous labels).
During measuring the label and gap length small differences can occur. Therefore the values can be set manually in the menu
'Label layout/Label and Gap'.
84
•
Dispensing edge (printers with dispenser option only).
•
Power cable.
•
Documentation + Printer driver CD.
English