Daily Cleaning Of All Steel Components; Daily Cleaning Of All Glass Components; Daily Oven Cleaning; Cleaning For Prolonged Deactivation - MBM EVC277 Betriebsanleitung

4.
ROUTINE MAINTENANCE

Daily cleaning of all steel components

Use a standard sprayer to apply the liquid detergent on the whole surface of the cooking
compartment and, using a non-abrasive sponge, clean the entire surface thoroughly by
hand.
When finished, rinse the cooking compartment abundantly with tap water (do not use
pressurised and/or direct water jets).
When these operations have been performed successfully, dry the cooking compartment
carefully using a non-abrasive cloth. If necessary, repeat the operations described above
for a new cleaning cycle.

Daily cleaning of all glass components

Wait for the equipment cooling.
Do not use pressure and/or direct water jets.
Use a suitable tool to remove all traces of dirt. Apply a suitable detergent on the surface
and clean with care using a damp cloth.
Wipe the cooking area by a not abrasive cloth.
Repeat this operation, if necessary.

Daily oven cleaning

Depending on the appliance, remove: grills, trays or other objects removed from the
cooking compartment.
Heat up the cooking compartment for about 20'.
Open the door to let the cooking compartment cool off for a few seconds.
Use a standard sprayer to apply the liquid detergent on the whole surface of the cooking
compartment and, using a non-abrasive sponge, clean the entire surface thoroughly by
hand.
When finished, rinse the cooking compartment abundantly with tap water (do not use
pressurised and/or direct water jets).
When these operations have been performed successfully, dry the cooking compartment
carefully using a non-abrasive cloth.
If necessary, repeat the operations described above for a new cleaning cycle.
Clean the parts previously removed from the cooking compartment (grills, trays and other
removable objects) with detergent and tap water, rinse them carefully and dry them before
putting them back.
In order to eliminate all humidity, once routine cleaning has been finished, turn the appliance
on and run it at minimum for approximately 5' and then turn it back off (see procedure part
3 Instructions for use: Switching On/Off).

Cleaning for prolonged deactivation

When the appliance remains idle for a long time, perform all the described daily cleaning
procedures.
For steel components. When the operations are over, protect the parts more exposed to
oxidation doing as follows.
•
Use lukewarm water with a bit of soap to clean the parts;
•
Rinse the parts thoroughly, without using pressurised and/or direct water jets;
•
Dry the surfaces carefully using non-abrasive material;
•
Wipe a non-abrasive cloth lightly soaked with food-safe Vaseline oil over all of the
stainless steel surfaces in order to create a protective film.
For glass components, apply with a soft cloth a layer of protective wax specific for the
material.
Air out the appliances and rooms regularly.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 13 - 13