Silvercrest SSRA1 Bedienungs- Und Sicherheitshinweise Seite 56

Reason
The robot vacuum cleaner
is not on the floor.
Anti-drop sensor
21
malfunction
Anti-collision sensor
23
malfunction
The robot vacuum cleaner
is stuck.
Fan malfunction
Battery malfunction
Anti-collision sensor
module malfunction
Gyro navigation module
error
Battery low
HEPA filter clogged
6
Dust collector is full
17
Problem
The robot vacuum cleaner
does not charge.
56 GB/IE
Display Signal tone
Beeps: two
E21
Beeps: two
E22
E23 Beeps: two
Beeps: three
E31
Beeps: three
E32
E41 Beeps: three
Beeps: four
E42
Beeps: five
E43
Reason
The robot vacuum cleaner is not mak-
ing good contact with the charging
contacts on the charging dock
3
The charging dock is switched off
2
and the robot vacuum cleaner is
switched on, draining the battery.
Solution
Move the robot vacuum cleaner
to a clear area and restart.
Check anti-drop sensor
Check anti-collision sensor
Move the robot vacuum cleaner
to a clear area and restart.
Restart the robot vacuum cleaner.
Please contact customer service
if you are unable to resolve the
problem.
Replace battery
Restart the robot vacuum cleaner.
Please contact customer service
if you are unable to resolve the
problem.
Restart the robot vacuum cleaner.
Please contact customer service
if you are unable to resolve the
problem.
Use the remote control to return
the robot vacuum cleaner to the
charging dock. If the robot vacuum
cleaner is on Standby, ensure it is
charged so it will always have
enough power to clean.
Clean HEPA filter
Empty dust collector
Solution
Ensure there is good contact be-
tween the robot vacuum cleaner
. and the charging contacts
2
the charging dock
We recommend continuous
charging when the robot vacuum
cleaner is not in use to ensure it
has enough power for the next
cleaning.
21
23
.
6
.
17
on
3
.
2