Operation
Changing/inserting the tool/collet chuck
CAUTION!
►
The shaft diameter of the tool must exactly match the clamp
bore of the collet chuck
♦
Hold the spindle
♦
Unscrew the collet chuck nut
assembly tool
♦
Insert the tool into the collet chuck
♦
Hold the spindle
♦
Tighten the collet chuck nut
■
Ensure the accessory tool is firmly attached .
CAUTION!
►
If no tool is inserted into the collet chuck
the collet chuck nut
by hand only!
Switching on and off
Switching on:
♦
First, press the trigger lock
down to switch the tool on .
Switching off:
♦
Release the trigger
♦
When you have finished working, disconnect the tool from the
compressed air source .
■
70
│
GB │ MT
/
(Ø 6 .35 mm/3 .2mm)!
using the assembly tool
from the thread using the
.
using the assembly tool
using the assembly tool
with the assembly tool
forwards and then the trigger
.
.
/ .
.
/ , do not tighten
, screw it on
PDSS 16 A1
.