You have the following options:
♦
Attach a maintenance unit with an oiler to the compressor .
♦
Install an add-on oiler in the compressed air line or the
compressed air tool .
♦
Add 3–5 drops of pneumatic oil into the connector nipple
after every 15 minutes of operation .
Connecting to a compressed air source
NOTE
►
Before connecting the compressed air source,
–
the correct working pressure (6 .3 bar) must be fully reached,
and
–
make sure that the trigger is in the upper position .
►
Use only connection hoses with an internal diameter of at least
9 mm .
►
Use only filtered, lubricated and regulated compressed air .
♦
Attach the tool to a compressor by connecting the connector
nipple
with the supply hose of the compressed air source .
CAUTION!
►
Ensure that the compressed air hose is firmly attached . A loose
hose can thrash about uncontrollably causing grave danger .
Likewise, ensure the firm seat of the two screw connections
between the coupling piece and the appliance .
♦
The compressed air source must be equipped with a pressure
reducer so that you can regulate the air pressure .
PDSS 16 A1
GB │ MT
│
69
■