Hazards Caused By Flying Parts; Hazards Caused By Entanglement - Parkside PDSS 16 A1 Originalbetriebsanleitung

readability . If damaged, have parts repaired or replaced before
using the compressed air tool . Many accidents are caused by
poorly maintained compressed air tools .

Hazards caused by flying parts

■ If a workpiece or accessory of the compressed air tool breaks,
parts can be flung out at high speeds .
■ Always wear impact-resistant safety goggles during operation,
when replacing accessory parts or during repair or maintenance
of the compressed air tool . The level of the required protection
must be evaluated separately for each individual task .
■ You must ensure that the workpiece has been securely fixed in
place .
■ Check regularly that the rotation speed of the compressed air tool
is not higher than the specified rotation speed appended on the
compressed air tool . These rotation speed tests must be
conducted without any accessory tools attached .
■ Ensure that sparks and fragments created during work do not
constitute a hazard .
■ Separate the compressed air tool from the compressed air supply
before replacing the attachment or accessories or before you
adjust the settings, service or clean the tool .
■ Ensure that no dangers are created for other persons either .

Hazards caused by entanglement

■ Dress properly . Do not wear loose clothing or jewellery . Keep
hair, clothing and gloves away from the compressed air tool and
moving parts . Loose clothes, jewellery or long hair can be caught
in moving parts . There is a risk of personal injury .
■ Suffocation, scalping and/or cuts may occur if loose-fitting
clothing, jewelry, necklaces, hair or gloves are not kept away
from the machine and its accessories .
■ 60 │ GB │ MT
PDSS 16 A1