Assembly; Operation; Switching On/Off; Dry Vacuuming - Parkside PNTS 1400 H4 Gebrauchsanweisung, Originalbetriebsanleitung

• Observe the instructions for
cleaning and maintenance of
the machine.
• Store the appliance in a dry
place and out of reach of chil-
dren.

Assembly

Pull out the mains plug.
Danger of electric shock.
The appliance is supplied with the
folded filter (
1. Place the 5 steering castors (11) onto
the mounts on the stainless steel con-
tainer (9).
2. Push the bow handle (1) onto the two
bow handle tie bars (2) and screw it in
place with 2 crosshead bolts (1a).
3. Place the motor head (3) on the stain-
less steel container (9).
4. Close the stainless steel container by
folding up the bow handle and fixing it
with the locking levers (14). everal po-
sitions are possible for the bow handle.
The locking lever must be tightened so
that a tensioning with medium force
can be carried out. You can set the ten-
sion by turning the locking lever:
- Tighten: turn clockwise
- Loosen: turn anti-clockwise.
5. Place the carrying handle (4) on the
motor head (3) and screw it on tight
with 2 crosshead screws (4a).
6. Fit the accessories:
- Connect the suction hose (19).
- Fit the handle (20)
- Fit the telescopic suction pipe (17).
(Press the knob on the telescopic suc-
tion pipe in the
separate to the desired length).
23) fitted.
direction and
- Fit the desired nozzle (25/26).
Never vacuum without a filter!
To store the suction set during
breaks, push together the telescopic
suction hose (17) and plug the suc-
tion pipe holder (18) into the socket
on the motor housing (see picture
below).

Operation

Fully unwind the suction hose
( 19) before commencing work.

Switching on/off

Connect the mains plug.
Do not vacuum without a filter!
(How to insert the filter is described
in the chapters "dry vacuuming"
and "wet vacuuming").
Switching On:
On/Off Switch (
Switching Off:
On/Off Switch (

Dry vacuuming

The appliance is supplied with the
folded filter (23) fitted.
Vacuuming with a fluted filter:
1. For dry vacuuming, fit the fluted filter
(23) onto the filter basket (27) on the
motor head (3)
If the sealing lip of the folded filter
(23) does not spontaneously touch
GB MT
6) In position "I".
6) In position "0".
37