Assembly; Operation; Switching On/Off; Washer Function - Parkside PWS 20 A1 Originalbetriebsanleitung

GB IE
• Ensure that the machine is cor-
rectly assembled and the filters
are in the correct position.
• Do not use without the filter. This
could damage the machine.
• Only use replacement parts
and accessories delivered and
recommended by our Service
Centre. The use of parts by
other manufacturers immediately
renders the guarantee void.
• Only have repairs carried out at
our authorised customer service
points.
• Observe the instructions for
cleaning and maintenance of
the machine.
• Store the appliance in a dry
place and out of reach of chil-
dren.

Assembly

Pull out the mains plug.
Danger of electric shock.
1. Attach the castors (8) with accessory
holders (8a) to the underside of the
container (7).
2. Fasten the castors (8) using the Phillips
screws (25).
3. Place the motor housing (4) on top of
the container (7) and close it with the
clips (6).
The motor head (4) can only be placed
in one position on the container (7).
The air flow control (3) and the device
socket (11) must be above the suction
connection (10). The water duct con-
nector (5) must be above the suction
connector (10).
4. Installing the accessories:
- Push the vacuum hose (16) into the
suction connection (10) until it locks
in place.
20
To remove it, press the catch (18)
and pull the vacuum hose (16).
- Connect the water duct at the suc-
tion hose (17) to the water duct con-
nector (5).
- Press the water tank (19) into the
holders on the back of the motor
head (4) and the container (7).
- Assemble the suction pipes (14).
Make sure to connect the water
channels (13+17) correctly. To disas-
semble the suction pipes, press the
release (13a) on the water duct and
pull the suction pipes apart.
- Install the nozzle (
N ever vacuum without a filter!
The nozzles (
tached directly onto the handle with
air regulation (15).

Operation

Fully unwind the suction hose
( 16) before commencing work.

Switching on/off

Connect the mains plug.
Switching on the vacuum cleaner
(Permanent operation):
Move the On/Off switch (
position.
Switching off the vacuum cleaner:
Move the On/Off switch (
position.

Washer function

Switching on the washer function
1. Turn the appliance on (On/Off switch).
2. Move the pump switch (3) to position
"1".
20-24) desired.
20-24) can be at-
2) to the "I"
2) to the "0"