Charging The Battery; Preparing The Appliance En - hanseatic VC-PD510 Gebrauchsanleitung

4. Place the wall plugs into the
holes.
5. Attach the wall bracket to the
wall using the two screws.

Charging the battery

For the first time please fully
charge the battery. The normal
charging time of the battery is
4-5 hours.
To improve the service life of the
battery, leave it fully discharged
during operation, i.e. use the de-
vice until it comes to a standstill.
To prevent deep discharge, char-
ge the battery every 3 months,
even if you do not need the de-
vice during this time.
1. Insert the plug of the power
adapter (12) into the charging
port (5) for the charging cable
on the battery.
2. Connect the mains plug to a
properly installed socket.
The battery operating light (4)
turns red.
3. Once the battery is charged
(when the operating light is
green), remove the plug of the
power adapter (12) from the
charging port (5) for the charg-
ing cable.
Start-up Page EN-13
Preparing the appliance
(20)
(6)
1. Insert the battery (6) onto the
handle of the appliance.
Make sure that the guide
rails (19) on the appliance
slide into the guide rails (20)
on the battery (6).
(11) (21) (22)
2. Insert the connector (21) on
the tube extension (11) into the
opening (22) on the suction
tube (8).
(19)
(8)