Start-Up; Unpacking The Appliance En; Mounting The Wall Bracket - hanseatic VC-PD510 Gebrauchsanleitung

Page EN-12

Start-up

Start-up
Unpacking the appliance
NOTICE
Risk of damage!
Improper handling of the ap-
pliance may result in damage.
Do not use sharp objects to
■
unpack the appliance.
1. Unpack the appliance.
2. Carefully remove all parts of
the packaging, plastic profiles,
tape and foam padding.

Mounting the wall bracket

WARNING
Risk of injury!
Improper installation of the
appliance can lead to injury.
Before drilling the holes,
■
ensure that no wires or
cables (power, gas, wa-
ter etc.) will be damaged
(check with a line locator).
NOTICE
Risk of damage!
Improper handling of the ap-
pliance may result in damage.
Check the condition of the
■
wall before mounting the
wall bracket.
You should mount the wall brack-
et before setting up the appli-
ance.
Screws and wall plugs
You will need:
– 2 round-headed screws
– 2 suitable dowels
Tools and aids
You will need:
– Screwdriver
– Drill with drill bit suited to the
nature of the wall
– Measuring tape / ruler
– Level
– Pencil
The upper drill hole must
be at least 102 cm above
the ground.
1. Start by drawing a vertical
guide line on the wall using a
pencil.
It is best to use a spirit level for
this.
2. Mark out the drill holes.
The upper drill hole must be at
least 102 cm above the ground;
the distance between the drill
holes should be 10.2 cm.
3. Drill holes at the marked points,
using a diameter that can ac-
commodate the wall plugs.