Charging The Battery; Preparing The Appliance En - hanseatic VC-PD510-1 Gebrauchsanleitung

2. Mark out the drill holes.
The upper drill hole must be at
least 95 cm above the ground;
the distance between the drill
holes should be 10.5 cm.
3. Drill holes at the marked
points, using a diameter that
can accommodate the wall
plugs.
4. Place the wall plugs into the
holes.
5. Attach the wall bracket to the
wall using the two screws.

Charging the battery

For the first time please fully
charge the battery. The normal
charging time of the battery is
4-5 hours.
To improve the service life of the
battery, leave it fully discharged
during operation, i.e. use the de-
vice until it comes to a standstill.
To prevent deep discharge, char-
ge the battery every 3 months,
even if you do not need the de-
vice during this time.
1. Insert the plug of the power
adapter (12) into the charging
port (5) for the charging cable
on the battery.
Start-up Page EN-13
2. Connect the mains plug to a
properly installed socket con-
tact.
The battery operating light (4)
turns red.
3. Once the battery is charged
(when the operating light is
green), remove the plug of the
power adapter (12) from the
charging port (5) for the charg-
ing cable.
Preparing the appliance
(19)
(6)
1. Insert the battery (6) onto the
handle of the appliance.
Make sure that the guide
rails (18) on the appliance
slide into the guide rails (19)
on the battery (6).
(18)