Routine Maintenance - Comet KF Steel 12/100 Bedienungsanleitung

STOPPING THE CLEANER – TIMED SHUTDOWN MODE
• If the cleaner remains in Total Stop mode for more than 15 minutes, it will switch off completely and
the warning light (29) will light up. To resume work, turn the master switch (1) to "0" and wait for a
few seconds before repeating the procedure to start up the cleaner as described in
.
CLEANER"
• Run the cleaner for a few minutes with cold water.
• Close the tap on the water supply off completely (or remove the suction pipe from the draft tank).
• Drain the water out of the cleaner by running it for a few seconds with the cleaner gun lever (24)
pressed.
• Turn the master switch (1) to "0".
• Take the plug out of the power socket.
• Eliminate any remaining pressure in the high pressure hose (21) by keeping the cleaner gun lever (24)
pressed down for a few seconds.
• Wait for the cleaner to cool down.
• Wind up the high pressure hose (21) with due care, making sure it is not bent.
• Wind up the power cord (6).
• Store the high pressure cleaner in a clean, dry place. Make sure the power cord and the high pressure
hose are not damaged.
Follow the instructions for
MAINTENANCE
SCHEDULE
Ever y time the • Check the power cord, the high pressure hose, the connectors, the cleaner gun and
cleaner is used
Once a Week • Check the water inlet filter and clean it if necessary.
Once a Month • Clean the nozzle.
• Check the pump oil level.
STOPPING

ROUTINE MAINTENANCE

"STOPPING WORK"
the lance pipe.
Should any of these look damaged, do not use the cleaner for any reason and
contact a
QUALIFIED TECHNICIAN
Unscrew the whole filter and remove the filter cartridge.
Running water or compressed air is generally all that is needed to clean the filter
cartridge. In difficult cases, use a lime scale remover or replace the filter cartridge.
For tough cases, use a lime scale remover or replace it by contacting a
to buy the spare part.
TECHNICIAN
Replace the filter.
To clean the nozzle, it is generally sufficient to insert the pin (18) supplied into the
nozzle's hole. If no appreciable results are obtained, contact a
to buy the spare part . The nozzle can be replaced using a 14 mm/0.55" spanner
(not supplied).
STORAGE
and those provided in the table below.
ACTION
.
"OPERATING THE
QUALIFIED
QUALIFIED TECHNICIAN
EN
27