Routine Maintenance; Supplementary Maintenance - Comet KF series Bedienungsanleitung Und Wartungsanleitung

• Store the high pressure cleaner in a clean, dry place. Make sure the power cord and the high pressure
hose are not damaged.
Follow the instructions for
MAINTENANCE
SCHEDULE
Ever y time the • Check the power cord, the high pressure hose, the connectors, the cleaner gun and
cleaner is used
Once a Week • Check the water inlet filter (18) and clean it if necessary.
Once a Month • Clean the nozzle.
• Check the pump oil level.
Supplementary maintenance should only be carried out by a
table below (guideline only).
MAINTENANCE
SCHEDULE
Every 200 hours • Check the pump's hydraulic circuit
• Check the pump is firmly secured
• Adjust the electrodes
Every 500 hours • Change the pump oil
• Replace the electrodes
• Replace the fuel nozzle.
• Check the pump delivery/suction valves.
• Check the tightness of pump screws.

ROUTINE MAINTENANCE

"STOPPING WORK"
the lance pipe.
Should any of these look damaged, do not use the cleaner for any reason and
contact a
QUALIFIED TECHNICIAN
Use a coin (Fig. 6) to turn the screw anticlockwise (37) and remove it; press the
lever (38) downwards and remove the cover (33) Unscrew the whole filter and
remove the filter cartridge.
Running water or compressed air is generally all that is needed to clean the filter
cartridge. In difficult cases, use a lime scale remover or replace the filter cartridge.
For tough cases, use a lime scale remover or replace it by contacting a
to buy the spare part.
TECHNICIAN
Replace the filter and put the cover back, following the above steps in reverse order.
To clean the nozzle, it is generally sufficient to insert the pin (31) supplied into the
nozzle's hole. If no appreciable results are obtained, contact a
to buy the spare part . The nozzle can be replaced using a 14 mm/0.55" spanner
(not supplied).
Use the dipstick (51) (Fig. 6). If you need to top up the oil, contact a
TECHNICIAN.

SUPPLEMENTARY MAINTENANCE

(water).
and those provided in the table below.
ACTION
.
QUALIFIED TECHNICIAN
ACTION
• Clean the fuel nozzle.
• Check/replace the fuel filter.
• Check/replace the water filter
• Check the pump's adjustment valve
• Clean the boiler.
• Remove any lime scale on the heating
element ("CLASSIC" version only).
• Check the safety devices
QUALIFIED
QUALIFIED TECHNICIAN
QUALIFIED
, following the
EN
29