Additional Safety Instructions - Parkside PALA 20-Li A1 Gebrauchsanweisung, Originalbetriebsanleitung

■ To protect yourself from falling branches, do not
stand directly under the branch or twig being
cut. The pruning shears should not be held at an
angle greater than 60° to the ground surface.
■ To reduce the risk of injury from moving parts,
always stop the product, ensure that all moving
parts are stopped, and remove the battery
before
–
You clean or remove a blockage
–
You leave the product unattended
–
You fit or remove attachments.
–
You check, maintain or work on the product
■ Keep the unit clean from cuttings and other ma-
terial. They can get stuck between the clamping
jaw and the blade.

Additional safety instructions

■ Do not allow yourself to get lulled into a false
sense of security and do not ignore the safety
regulations for power tools, even if you are
familiar with the power tool after repeated use.
■ Careless handling can lead to serious injuries
within seconds.
■ Keep handles and grasping surfaces dry, clean
and free from oil and grease.
■ Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool
in unexpected situations.
■ Do not use a damaged or modified battery.
■ Damaged or modified batteries may behave
unexpectedly and cause fires, explosions or
pose a risk of injury.
■ Do not expose a battery to fire or excessively
high temperatures.
■ Fire or temperatures above 130°C may cause
an explosion.
│ GB │ IE │ NI
■ 8
■ Follow all instructions regarding charging and
never charge the battery or the cordless tool
outside the temperature range given in the oper-
ating instructions.
■ Incorrect charging or charging outside of the
permissible temperature range can destroy the
battery and increase the risk of fire.
■ During cutting, keep the area clear of bystanders,
children and animals.
■ When cutting a branch under tension, make
sure that you are not hit by wood that snaps
back when the resistance is removed.
■ Look after the product carefully. Keep the cut-
ting edge sharp and clean for optimum perfor-
mance and to reduce the risk of injury.
■ Before each use and after each impact, check
that no parts are damaged. Any damaged part
must be properly repaired or replaced by au-
thorised service personnel.
■ If the product has been dropped or received
a heavy blow or begins to vibrate abnormally,
stop the product immediately and inspect it for
damage or identify the cause of the vibration.
Any damaged parts must be properly repaired
or replaced by authorised service personnel.
■ Check damaged parts. Before continuing to use
the tool, any damaged safety devices or other
damaged parts must be carefully inspected to
determine whether they function properly.
■ Do not cut where there is a risk of hidden cables.
■ Do not cut any cables.
■ Keep the working area free of cables and wires
(e.g. chains of lights).
PALA 20-Li A1