First Aid; Packaging; Ec Declaration Of Conformity - Makita RBC2500 Original Bedienungsanleitung

Never straighten or weld damaged cutting tools.
– Operate the Brush cutter/String trimmer with as little noise and contamination as
possible. In particular check the correct setting of the carburetor.
– Clean the Brush cutter/String trimmer at regular intervals and check that all
screws and nuts are well tightened.
– Never service or store the Brush cutter/String trimmer in the vicinity of naked
flames.
– Always store the Brush cutter/String trimmer in locked rooms and with an emptied
fuel tank.
Observe the relevant accident prevention instructions issued by the relevant trade
associations and by the insurance companies.
Do not perform any modifications on the Brush cutter/String trimmer as this will
endanger your safety.
The performance of maintenance or repair work by the user is limited to those
activities as described in the instruction manual. All other work is to be done by an
Authorized Service Agent. Use only genuine spare parts and accessories released
and supplied by MAKITA.
Use of non-approved accessories and tools means increased risk of accidents.
MAKITA will not accept any liability for accidents or damage caused by the use of
non-approved cutting tools and fixing devices of cutting tools, or accessories.

First Aid

In case of accident make sure that a first-aid box is available in the vicinity of
the cutting operations. Immediately replace any item taken from the first aid
box.
When asking for help, please give the following information:
– Place of accident
– What happened
– Number of injured persons
– Kind of injuries
– Your name

Packaging

The MAKITA Brush cutter/String trimmer will be delivered in two protective
cardboard boxes to prevent transport damage. Cardboard is a basic raw material
and is therefore consequently reusable or suitable for recycling (waste paper
recycling).
Brush cutter: model RBC2500, RBC2510 (See TECHNICAL DATA for the specifications)
We declare under our sole responsibility that this product is in compliance with the following Directives, 2000/14/EC, 2006/42/EC.
The most important standards applied to properly meet the requirements of the adove Directives were: EN11806.
Measured Sound Power: 110 dB
Guarantee Sound Power: 114 dB
These sound power levels were measured in accordance with Council Directive, 2000/14/EC.
Conformity assessment procedure: Annex V.
Responsible Manufacturer:
Makita Corporation.
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 8JD, ENGLAND
EC-DECLARATION OF CONFORMITY
3rd. NOV. 2009
Tomoyasu Kato
Director