Maintenance; Legal Information; Technical Data - Ottobock 12K41 Gebrauchsanweisung (Benutzer

Cleaning
8 Cleaning
1) Clean the product with a damp cloth and mild soap (e.g. Ottobock 453H10=1 Derma Clean) when needed.
Ensure that no liquid penetrates into the system component(s).
2) Dry the product with a lint-free cloth and allow it to air dry fully.

9 Maintenance

We recommend performing regular maintenance (service inspections) to prevent injuries and maintain the quality
of the product. This should be carried out when the maintenance interval expires, i.e. after 24 months. The manu­
facturer grants a grace period of no more than one month before or three months after the due date. The mainten­
ance includes inspecting the sensors and replacing wear and tear parts.
In general, all products are subject to compliance with the maintenance intervals during the warranty period. This
is the only way to maintain full warranty cover.

10 Legal information

10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
10.2 Trademarks
All product names mentioned in this document are subject without restriction to the respective applicable trade­
mark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of the respective
owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justify the conclusion
that the denotation in question is free of third-party rights.
10.3 CE conformity
The product meets the requirements of the RoHS Directive 2011/65/EU on the restriction of the use of certain haz­
ardous substances in electrical and electronic devices.
This product meets the requirements of the European Directive 93/42/EEC for medical devices. This product has
been classified as a class I device according to the classification criteria outlined in Annex IX of the directive. The
declaration of conformity was therefore created by the manufacturer with sole responsibility according to Annex VII
of the directive.

11 Technical data

Environmental conditions
Storage and transport in original packaging
Storage and transport without packaging
Operation
Reference number
Current draw (in mA)
Power supply
Max. load in locked state (N)
Flexion angle (in °)
Service life
18
-25 °C/-13 °F to +70 °C/+158 °F
-20 °C/-4 °F to +40 °C/+104 °F
max. 93 % relative humidity, non-condensing
+5 °C/+41 °F to +40 °C/+104 °F
max. 93 % relative humidity, non-condensing
12K41=* 12K42=*
- -
- -
12K44=*
-
-
230
15°–145°
5 years
12K41, 12K42, 12K44, 12K50
12K50=*
3.5
757B20
757B21
757B25=*
757B35=*