Starting charging:
♦
Connect the micro USB plug of the charging cable
charging socket
♦
Connect the USB plug of the charging cable
.
♦
Connect the charger
source.
The battery is fully charged when the battery level display
from red to green.
Stopping charging:
♦
Disconnect the charger
♦
Disconnect the micro USB plug of the charging cable
the charging socket
Changing bits/screw driver bits (see fig. B)
Inserting:
♦
Insert a bit
Removal:
♦
Pull the bit
PAS 4 B4
.
to a 100 - 240 V ∼ 50 - 60 Hz power
from the mains power supply.
.
into the tool holder
out of the tool holder
9b
9a
to the charger
.
.
GB │
to the
changes
9b
from
IE│
41
■