Charging - Parkside PASD 4 B2 Originalbetriebsanleitung

GB
g) Avoid mechanical dam-
age to the charger. This
can lead to internal
short circuits.
h) The charger must not
be operated on or near
flammable surfaces
(e.g. paper, textiles).
Risk of fire due to
heating caused by

charging.

j) In order to minimise
the risk of electric
shock, pull the charger
plug out of the socket
prior to cleaning it.
k) If the connection ca-
ble of this device is
damaged, it must be
replaced by the man-
ufacturer or their cus-
tomer service or by a
similarly qualified per-
son in order to avoid
hazards.
l) Do not attempt to charge
non-rechargeable batter-
ies in the charger.
38
Charging
Do not expose the battery
to extreme conditions
such as heat and shocks. There
is a risk of injury caused by
leaking electrolyte solution! In
case of contact with eyes or
skin, rinse the affected sites
with water or a neutralizer and
seek medical attention.
The battery must only be
charged up in dry areas.
There is a risk of personal inju-
ries from an electric shock.
• The device may only be
powered with SELV (Safety
Extra Low Voltage) as indi-
cated by the label on the
device.
• Charge the battery before
using it for the first time.
• The device is designed for
power supplies with the cha-
racteristics 5 V and 1.7 A.
Use the original Parkside
power supply with or-
der number 80001038
(JLH100501700G1) for EU