Parts Identification; Safety Devices; Standard Equipment - Comet K series Bedienungs- Und Wartungsanleitung

Refer to figures 1, 2, 3, 4, 6, 7 and 8.
1 Master switch
2 Handle bar
3 Lance holder
4 Warning plate. Informs on the residual risks: Use before
reading the instruction manual is prohibited; use for
washing people, animals, electrical equipment and the
high-pressure cleaner itself is prohibited
5 Identification plate. Indicates the serial number and main
technical characteristics
6 Power supply cable
7 Delivery pipe holder
8 Pressure adjustment knob
9 Fixing screws
10 Cable reel
11 Detergent tank cap
12 Hose reel
13 Pressure gauge
14 Hose reel knob
15 Hose reel locking handle
16 Water outlet connector
17 Water inlet connector
18 Water inlet filter
19 Detergent tank
20 Detergent level indicator
• Amperometric protection.
This device stops the high-pressure water cleaner in the event of electrical overcurrent.
Carry out the following if activated:
- Place the master switch (1) in position "0" and disconnect the plug from the wall socket;
- Press lever (22) of the gun to discharge possible residual pressure;
- Wait 10-15 minutes to allow the high-pressure cleaner to cool;
- Check that the requirement for the mains power connections have been respected (see the
MANUAL - SAFETY WARNINGS
- Reconnect the plug and repeat the start procedure described at paragraph "
• Pressure restriction/adjustment valve.
This valve that is set by the Manufacturer allows to adjust the operating pressure by means of knob (8) and allows
the pumped liquid to return to the pump suction, preventing the development of hazardous pressures when the gun
is closed or when a pressure value is set over the maximum allowed.
• Gun lever blocking device.
This safety catch (23) allows to block the lever (22) of the gun (24) in the closed position, preventing accidental
activation (Fig. 3, position S).
Make sure that the following parts are included in the packaging of the purchased product:
• High-pressure cleaner
• High-pressure delivery pipe with quick-fit connector
• Complete hose reel
• Gun;
• Lance pipe;
• Delivery pipe holder
• Handlebar
(MOBILE, MOBILE HOSE REEL)
• Handlebar fixing kit
• Suction connector kit;
• External detergent suction pipe kit;
• Instruction manual - Safety warnings
• Instruction manual - Use and maintenance;
14

PARTS IDENTIFICATION

SAFETY DEVICES

), paying particular attention to the extension lead used;

STANDARD EQUIPMENT

(MOBILE HOSE REEL)
;
(MOBILE)
(MOBILE, MOBILE HOSE REEL)
21 Detergent tank release
22 Gun lever
23 Gun lever safety catch
24 Gun
25 Water inlet hose connector
26 Water inlet hose connector seal
27 Handle
28 Oil level indicator
29 Lance pipe
30 Nozzle holder head
31 Nozzle cleaning pin
32 Detergent suction connection from external tank
33 External detergent suction cap
34 Detergent suction pipe
35 High-pressure pipe
36 High-pressure pipe quick connector
37 External detergent suction pipe connector
38 External detergent suction pipe
39 External detergent suction pipe filter
40 Handle retainer
41 Housing compartment
42 Connection pipe
43 High-pressure pipe connector
(MOBILE, PICK-UP)
;
;
;
".
OPERATION
;
INSTRUCTION