Transport And Storage Conditions; Installation; Personnel Requisition; Safety During Installation - Wilo Stratos MAXO Einbau- Und Betriebsanleitung

4.4

Transport and storage conditions

The pump and its packaging must be protected against moisture,
frost and mechanical damage during transport and temporary stor-
age.
WARNING
Risk of injury from sodden packaging!
Packaging that has been sodden loses its strength
and can cause injury to persons if the product falls
out.
WARNING
Risk of injury from ripped plastic strips!
Ripped plastic strips on the packaging render trans-
port protection void. Products falling out may cause
personal injury.
▪ Store in original packaging.
▪ Storage of pump featuring horizontal shaft on a horizontal surface.
Observe the packaging icon
▪ Only carry motor or pump housing. If necessary use hoisting gear
with sufficient bearing capacity ➜ Fig. 6.
▪ Protect against moisture and mechanical load.
▪ Permissible temperature range: -20 °C to +70 °C
▪ Relative humidity: 5 – 95 %
Installation and operating instructions Wilo-Stratos MAXO/-D/-Z
(top).
Domestic hot water circulators:
▪ Dirt and contamination should be avoided once the product is re-
moved from its packaging.
5

Installation

5.1

Personnel requisition

Carry out installation using qualified specialists only.
5.2

Safety during installation

WARNING
Hot fluids!
Hot liquids can cause scalding. Before the installation
or removal of the pump or the dismantling of the
housing screws observe the following:
1. Close shut-off device or drain unit.
2. Cool down the unit completely.
WARNING
Incorrect installation!
Incorrect installation can result in personal injury.
There is a crushing hazard!
There is a risk of injury due to sharp edges/burrs!
There is a risk of injury hazard due to the pump/mo-
tor falling!
en
35