Preparations; Installation; Installation Location - STIEBEL ELTRON DEM series Bedienung Und Installation

.CZ`<<`.HC
TVTV`.HCZ
Unpressurised taps
- WEN Sensor tap for washbasins
- MAW Wall mounted tap for oversink
- MAZ Twin lever basin tap
- MAE Mono lever basin tap
Pressure-tested tap
- WEH Sensor tap for washbasins
ZTA 3/4 - Central thermostatic valve
Thermostatic valve for central premixing, for example for operating
an instantaneous water heater with a solar thermal system.
9.

Preparations

f Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps/valves
f Use suitable taps (see chapter "Accessories").
qqq Z`. <é<`VHC HB
Note
Fitting the special aerator into the tap provides you with
an optimum water jet.

10. Installation

10.1 Installation location

Damage to the appliance and environment
Install the appliance in a room free from the risk of frost.
f Always install the appliance vertically near the draw-off
point.
f Ensure that the lateral cap fixing screws are always
accessible.
The appliance is suitable for undersink and oversink installations.
DANGER Electrocution
The adjusting screw for setting the flow rate is 'live', and
the IP25 protection is only given when the appliance back
panel is fitted.
f Always fit the appliance back panel.
B ’ Ñ