Safety; General Safety Instructions; Instructions, Standards And Regulations; Appliance Description - STIEBEL ELTRON SHO AC 600 6/12 Bedienungs Und Installationsanleitung Handbuch

INSTALLATION

Safety

INSTALLATION
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
8.

Appliance description

8.1

Standard delivery

The following are delivered with the appliance:
- Thermometer (delivered inside the control panel)
- Signal anode consumption indicator (delivered inside the
control panel)
- additional type plate
- Label "Signal anode information"
8.2

Accessories

Required accessories
Depending on the static pressure, safety assemblies and pressure
reducing valves are available. These type-tested safety assemblies
protect the appliance against impermissible excess pressure.
Further accessories
If it is not possible to fit an anode rod from above, install a seg-
mented signal anode.
Thermal insulation is also available as an accessory.
9.

Preparations

9.1

Installation site

Always install the appliance in a room free from the risk of frost
and near the draw-off point, and secure the appliance to the floor.
Ensure the floor has sufficient load bearing capacity and evenness
(see chapter "Specification / Data table").
www.stiebel-eltron.com
10. Installation

10.1 Cold water connection and safety assembly

10.1.1 Safety instructions
Note
Carry out all water connection and installation work in
accordance with regulations.
Material losses
!
When using plastic pipework, observe chapter "Specifi-
cation / Fault conditions".
Material losses
!
Operate the appliance only with pressure-tested taps.
Cold water line
Steel or copper pipes or plastic pipework are approved materials.
A safety valve is required.
10.1.2 Connection
f Place the cylinder in its final location and align it vertically. f
f Flush the pipes thoroughly. f
The max. permissible pressure must not be exceeded (see chapter
"Specification / Data table").
f Install a type-tested safety valve in the cold water supply f
line. Please note that, depending on the static pressure, you
may also need a pressure reducing valve.
f Connect the cold water inlet lines with the safety assembly. f
Connect the hydraulic connections with flat gaskets.
SHO AC | 21