Master ROTOPED R06 Benutzerhandbuch Seite 46

DIST (DISTANCE):
Displays the accumulative distance traveled during workout. When you start to exercise, distance starts
counting up from 0.0 to 999.9 km per 0.1km increment. You may also pre-set target distance in STOP mode
before training. To set DISTANCE press the MODE button until you see the DIST on the screen. Press the
SET button, DIST begins blinking. Press the SET button to change the distance, each time you press the SET
button DISTANCE should change by 1.0 km. Press the RESET button to clear the target distance to zero.
Once you pre-set target distance and then start to exercise, distance starts counting down from pre-set target
distance to 0.0. When the pre-set target distance counts down to 0.0, distance will start to count up immediately
and the computer will begin beeping to remind you.
CAL (CALORIES):
Displays the total accumulated calories burned during workout. When you start to exercise, calories start
counting up from 0.0 to 999.9 calories. You may also pre-set target calories in STOP mode before training. To
set CALORIES press the MODE button until you see the CAL on the screen. Press the SET button, CAL begin
blinking. Press the SET button to change the calories, each time you press the SET button CALORIES change
by 1.0 calorie. Press the RESET button to clear the target calories to zero. Once you pre-set target calories and
then start to exercise, calories start counting down from pre-set target calories to 0.0. When the pre-set target
calories count down to 0.0, calories will start to count up immediately and the computer will begin beeping to
remind you. (This data is a rough guide for comparison of different exercise sessions and should not be used in
medical treatment).
ODO (ODOMETER):
Displays the total accumulative distance traveled. The data values of ODO can not be clear to zero by pressing
and holding the MODE or RESET button for 3 seconds. If you take out the batteries from the computer, the
ODO data values will clear to zero.
(PULSE):
Displays your current heart rate figures after you grip the handlebar sensors with both your hands during
exercise. To ensure the pulse readout is more precise, please always hold on to the handlebar grip sensors with
two hands instead of just with one hand only when you try to test your heart rate figures. You may also pre-set
target heart rate in STOP mode before training. To set PULSE press the MODE button until you see the P on
the screen. Press the SET button, target heart rate begin blinking. Press the SET button to pre-set target heart
rate. Press the RESET button to clear the target heart rate to zero. The pre-set heart rate range is from 40 to
240 beats per minute. Once you pre-set target heart rate and then start to exercise, please grip the handlebar
sensors with both your hands during exercise. If the heart rate detected greater than the target heart rate, the
computer will begin beeping to remind you.
Specifikation
TIME ---------------------------------------------------
SPEED ------------------------------------------------
DIST (DISTANCE) ---------------------------------
CAL (CALORIES) ----------------------------------
ODO (ODOMETER) -------------------------------
(PULSE) ------------------------------------------
0:00-99:59 MIN: SEC
0.0-999.9 KM/H
0.0-999.9 KM
0.0-999.9 KCAL
0.0-9999 KM
40-200 BEATS/MIN
46
EN