Master ROTOPED R06 Benutzerhandbuch Seite 45

EN
4. Start workout
4.1 Function buttons
MODE:
Press the MODE button to select each function of computer.
Press and hold the MODE button for 3 seconds, all data values will clear to zero
except the ODO (ODOMETER) data values.
SET:
Press the SET button to set data values of TIME, DISTANCE, CALORIES, or Pulse for target pre-setting.
RESET:
Press the RESET button to clear data values of TIME, DISTANCE, or CALORIES to zero.
Press the RESET button to clear data values of TIME, DISTANCE, CALORIES, or Pulse to zero for target pre-
setting. Press and hold the RESET button for 3 seconds, all data values will clear to zero except the ODO
(ODOMETER) data values.
4.2 Computer functions
AUTO ON/OFF:
When you start to exercise or press any key on the computer, the computer will turn on. If you leave the
equipment for 256 seconds, the power will turn off automatically.
SCAN:
Press the MODE button until the screen displays SCAN; the computer will automatically scan the function of
TIME, SPEED, DIST (DISTANCE), CAL (CALORIES), ODO (ODOMETER), and (PULSE) every 6
seconds.
TIME:
Displays your elapsed workout time in minutes and seconds. When you start to exercise, time starts counting
up from 0:00 to 99:59 minutes per 1 second increment. You may also pre-set target time in STOP mode before
training. To set TIME press the MODE button until you see the TIME on the screen. Press the SET button,
TIME begins blinking. Press the SET button to change the time, each time you press the SET button TIME
should change by 1 minute. Press the RESET button to clear the target time to zero. The pre-set target time
range is from 00:00 to 99:00 minutes. Once you pre-set target time and then start to exercise, time starts
counting down from pre-set target time to 0:00 per 1 second backward. When the pre-set target time counts
down to 0:00, time will start to count up immediately and the computer will begin beeping to remind you.
SPEED:
Display the current training speed.
45