Operation; Power Supply; Switching On/Off; Switching On The Unit - Bosch BEA 070 Originalbetriebsanleitung

en 20 | BEA 070 | Operation
4.

Operation

!
Transport the BEA 070 only in an upright position
via the carrying handle. Select the installation
location such that the BEA 070 cannot fall and is
always correctly positioned (carrying handle at
top).
4.1

Power supply

The power supply is obtained from the lighting system.
The BEA 070 can operate at between 100 V and 240 V,
50/60 Hz.
!
Prior to start-up, make sure the lighting system
voltage coincides with the set voltage of the
BEA 070. If the BEA 070 is operated outdoors, it
is advisable to use a voltage source protected by
a residual current-operated circuit breaker. Only
operate the unit in dry conditions!
!
To avoid the formation of condensation, allow the
BEA 070 to adjust to ambient temperature before
switching it on.
i
The details of the power supply are provided on
a sticker on the back of the BEA 070.
4.2

Switching on/off

4.2.1

Switching on the unit

1. Plug the power cord into the BEA 070, and attach
to the holes (fig. 1, pos. 4) with a cable tie to
provide strain relief.
2. Connect the BEA 070 to the lighting system via the
power cord.
3. Press the On/Off button.
"
The LED flashes alternately orange and green (fig. 1,
pos. 12).
4.2.2

Switching off the unit

i
First exit from the exhaust gas test step, and wait
for the fan to stop running. Only then, switch off
the BEA 070.
¶
Press the On/Off button for more than two
seconds.
"
LED is not lit, the BEA 070 is off.
|
1 689 989 183 2019-07-24
4.3 Connecting the BEA 070 in stand-
alone mode
The following description for installing the BEA-PC
system software and configuring the BEA 070 only
applies if the BEA 070 is to run in stand-alone mode.
4.3.1

Installing the BEA-PC software

i
Pay attention to the system requirements before
starting installation.
i
Only plug in the Bluetooth USB adapter when
prompted to do so during software installation.
1. Close all open applications.
2. Insert the "SystemSoft BEA-PC" CD in the DVD
drive.
3. Start "Windows Explorer".
4. Start 'D:\RBSETUP.EXE' (D = DVD drive letter).
 Setup starts.
5. Confirm with <Continue>.
6. Follow the instructions on the screen.
7. Reboot the PC/laptop to successfully conclude
installation.
"
BEA is installed.
Robert Bosch GmbH