Initial Operation - Bosch DWM 40 L PROFESSIONAL Bedienungsanleitung

All manuals and user guides at all-guides.com
OBJ_BUCH-167-002.book Page 16 Wednesday, October 18, 2006 1
Operation

Initial Operation

Note: Protect the measuring tool
against moisture and direct sun irradia-
tion.
Switching On and Off
Press the "ON/OFF" switch 9 to
switch the measuring tool on or off.
After inserting or replacing the batter-
ies, the measuring tool is automatically
switched on.
After approx. 5 minutes without button
actuation or angle change, the measur-
ing tool switches off automatically to
preserve battery life.
Operating Instructions
Note: Keep the supporting surfaces
and contact edges 14 of the measuring
tool clean. Protect the measuring tool
against impact and shock. Debris par-
ticles or deformation can lead to faulty
measurements.
Measuring Angles (see figure D)
Position the fold-out leg 1 and the base
leg 6 plane against the edges to be
measured. The displayed reading cor-
responds with the internal angle w
between the base leg and the fold-out
leg.
The reading is indicated on both dis-
plays (on the front and rear side of the
base leg). The reading is indicated until
the legs are moved in relation to each
other.
Retaining the Measured Value
("HOLD")
The current reading can be retained in
the display by pressing the "HOLD"
button 8.
When the Hold mode is activated,
"HOLD" c is indicated in the display
and the Hold mode is confirmed by the
blinking of both the hold indicator and
the reading c. The reading remains
unchanged (even when the legs are
moved in relation to each other) until
the "HOLD" button 8 is pressed again.
16 | English
1 609 929 J96 • 18.10.06