Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Appliance; Switching On The Appliance; Selecting The Temperature; Operating Tips - Gaggenau rt 220 200 Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Connecting the appliance

After installing the appliance, wait at least. ½ hour before
switching on the appliance. During transportation the oil
in the compressor may have flowed into the refrigeration
system.
Before switching on the appliance for the first time,
clean the interior of the appliance (see Cleaning the
appliance).
The socket should be freely accessible.
Connect the appliance to 220 240 V/50 Hz alternating
current via a correctly installed earthed socket. The
socket must be fused with a 10 A fuse or higher.
If the appliance is to be operated in a non European
country, check on the rating plate whether the
indicated voltage and current type correspond to
the values of your mains supply. The rating plate is
located in the refrigerator compartment at the
bottom left hand side. The power cord may be
replaced by an electrician only.
Warning!
!
Never connect the appliance to electronic energy
saver plugs (e.g. Ecoboy: Sava Plug) or to power
inverters which convert the direct current to 230 V
alternating current (e.g. solar equipment, power
supplies on ships).
22

Switching on the appliance

Press the On/Off switch 2a. Interior light comes on,
temperature indicator light flashes.
At the factory the refrigerator compartment was set to
+5 °C.
We recommend a setting of +4 °C.
Perishable food should not be stored warmer than +4 °C.

Selecting the temperature

The set values can be changed, see Description of
control panel:

Operating tips

The refrigerator compartment temperature rises:
if the appliance door is opened frequently,
D
if large quantities of food are placed in the refrigerator
D
compartment.
Condensation droplets or frost in the refrigerator
compartment
While the refrigerating unit is running, beads of conden
sation or hoarfrost form at the back of the refrigerator
compartment. This is quite normal.
It is not necessary to wipe off the condensation or frost.
The rear panel defrosts automatically.
The condensation runs into the drainage channel. and
then to the refrigerating unit where it evaporates.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis