Eliminating Minor Faults Yourself - Gaggenau rb 287 Gebrauchsanleitung

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice, even if the appliance is still under guarantee!
Fault
Temperature differs greatly
from the set value.
Displays do not illuminate.
Floor of the refrigerator
compartment is wet.
The temperature in the
refrigerator compartment
is too cold.
The refrigerating unit
is switching on more
frequently and for longer.
Refrigerator has no cooling
capacity. capacity.
Appliance is not cooling,
temperature display lamps
and interior light are lit.
The interior light is not
functioning. functioning.
The temperature display
lamp 4 or 7 flashes.
Warning signal sounds and
the temperature display
lamp 4 is flashing.
40
Possible cause
Power failure; the fuse has been switched
off; the mains plug has not been inserted
properly.
The condensation channels or
condensation drainage pipe are blocked.
Temperature has been set too low.
The ventilation opening is covered.
Appliance has been switched off.
Power failure; the fuse has been switched
off; the mains plug has not been inserted
properly.
Showroom mode is switched on.
The LED light is defective.
Door was open too long.
Light switches off after approx. 10 min.
Appliance door opened frequently.
A lot of food was placed in the freezer.
Fault the freezer compartment is too
warm!
Frozen food is at risk!
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high, wait a few
hours and check whether the tem
perature has approached the set value.
If the temperature is too low, check
the temperature again the next day.
Check whether the power is on, the fuse
must be switched on.
Clean the condensation channels and
the outlet (see Cleaning the appliance").
Increase the temperature.
Remove obstacles.
Press main switch 8.
Check whether the power is on, check
the fuses.
Hold down alarm button 1 for 10 seconds
until an acknowledgement signal sounds.
After a short time check whether your
appliance is cooling.
See chapter Light (LED)" section.
When the door is closed and opened,
the light is on again.
Do not open the door unnecessarily.
Switch on super freezing before inserting
the food.
See chapter entitled Warning signal".