Eliminating Minor Faults Yourself - Gaggenau RT 222 Gebrauchsanleitung

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice – even if the appliance is still under guarantee!
Fault
Temperature differs greatly
from the set value.
Displays do not illuminate.
Temperature display indicates
"E..".
The light does not function.
There is a thick layer of frost
in the freezer compartment.
Floor of the refrigerator
compartment is wet.
The temperature
in the refrigerator
compartment is too cold.
The refrigerating unit
is switching on more
frequently and for longer.
Appliance is not cooling,
temperature display and light
are lit.
x
Possible cause
Power failure; the fuse has been
switched off; the mains plug
has not been inserted properly.
Electronics have detected a fault.
The LED light is defective.
Appliance was open too long.
Light is switched off after
approx. 10 min.
The condensation channel or drainage
hole are blocked.
Freezer compartment door is open.
Temperature has been set too low.
The "fast" function is switched on.
Appliance opened frequently.
The ventilation openings have been
covered.
Showroom mode is switched on.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has approached
the set value.
If the temperature is too low check the temperature
again the next day.
Connect mains plug. Check whether the power
is on, check the fuses.
Call customer service.
See chapter "Light (LED)" section.
When the appliance is closed and opened, the light
is on again.
Defrosting the freezer compartment (see chapter
Defrosting). Always ensure that the freezer
compartment door is closed properly.
Clean the condensation channel and the drainage
hole. See chapter Cleaning the appliance.
Close the freezer compartment door. The freezer
compartment door engages audibly.
Increase the temperature.
Switch off the "fast" function.
Do not open the appliance unnecessarily.
Remove obstacles.
Start appliance self-test (see chapter "Appliance
self-test").
When the programme has ended, the appliance
switches over to normal operation.
37