Observe Room Temperature; Installing The Appliance; Connecting The Appliance - Gaggenau rb 287 Gebrauchsanleitung

Observe room temperature

The appliance is designed for a specific climatic class.
Irrespective of the climatic class, the appliance can be
operated at the following room temperatures.
The climatic class can be found on the rating plate at
the bottom left hand side in the appliance.
Climate class
SN
N
ST
T
Ventilation
Conduction of the heated air must not be obstructed 20.
Otherwise, the refrigerating unit must work harder.
This increases power consumption.
Therefore: Never cover or block ventilation opening!

Installing the appliance

The appliance should be installed in a dry, well ventilated
room. The installation location should neither be exposed
to direct sunlight nor near a heat source, e. g. a cooker,
radiator, etc. If installation next to a heat source is
unavoidable, use a suitable insulating plate or observe
the following minimum distances to a heat source:
3 cm to electric or gas cookers.
30 cm to an oil or solid fuel cooker.
28
Ambient temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C

Connecting the appliance

After installing the appliance, wait at least 1 hour until
the appliance starts up. During transportation the oil in
the compressor may have flowed into the refrigeration
system.
Before switching on the appliance for the first time,
clean the interior (see Cleaning).
The socket should be freely accessible. Connect the
appliance to 220-240 V/50 Hz alternating current via
a correctly installed earthed socket. The socket must
be fused with a 10 to 16 A fuse.
If the appliance is to be operated in a non European
country, check on the rating plate whether the indicated
voltage and current type correspond to the values
of your mains supply. The rating plate is located in the
refrigerator compartment at the bottom left hand side.
The power cable must only be replaced by a technician.
Warning!
!
Never connect the appliance to electronic energy saver
plugs or to power inverters which convert the direct
current to 230 V alternating current (e. g. solar
equipment, power supplies on ships).