13 4. Initial Start-Up; 13 4.1 Esi[Tronic] 2.0 Software Installation; Connection; 13 4.3 Configuration (Ddc) - Bosch KTS 5 Serie Originalbetriebsanleitung

4. Initial start-up
4.1 ESI[tronic] 2.0 software installation
1. Installing ESI[tronic] 2.0.
2. Licensing ESI[tronic] 2.0.
i
ESI[tronic] 2.0 licensing is performed by way of a
file or online. Information on licensing can be found
in the ESI[tronic] 2.0 Online Help.
4.2

Connection

1. Connect the KTS 525 to the power supply unit
included in the scope of delivery.
2. Connect the KTS 525 to a PC/Laptop via the USB
connecting cable.
i
The message New hardware found
the screen for a few seconds the first time the
KTS 525 is connected by way of the USB connecting
cable. This indicates that the USB connection to the
KTS 525 has been recognized.
Robert Bosch GmbH
4.3
i
The function of the DDC (Diagnostic Device
Configuration) software is to configure, activate and
test the KTS modules.
1. Start DDC ("Start >> (All programs) >> Bosch >>
Diagnostic Device Control").
2. Add the KTS module via "New".
appears on
i
Other procedures for configuration concerning the
initial start-up are described in the online help. Use
<Help> to open the online help. All other important
information concerning DDC is found here as well.
i
If you have any questions which cannot be answered
by the online Help, please contact the ESI[tronic]
service hotline directly.
| KTS 525 (KTS 5 Series) | 17
Configuration (DDC)
1 689 989 171
en
|
2019-01-04