Storage; Transport; Troubleshooting; Service Information - Parkside PDUW 280 A1 Bedienungs- Und Sicherheitshinweise

12. Storage

Store the Multi-Purpose Air Tool without any tool inserts
(7-11) in it in a well oiled condition, standing or suspended
vertically with the striking mechanism downwards.
Note
• When not in use store the Multi-Purpose Air Tool in a dry,
well ventilated and frost-free (10-25 °C) place outside
the reach of children, e.g. on top of a high cupboard or
under lock and key.
• If possible, store the Multi-Purpose Air Tool, the Operat-
ing Manual and any accessories all together in the origi-
nal packaging. In this way you will have all information
and parts readily to hand.
m Fertiliser and other garden chemicals contain substanc-
es that can have a severely corrosive effect on the metal
parts. Do not store the device in the vicinity of these sub-
stances..

13. Transport

Remove the tool insert you were using from the Multi-Purpose
Air Tool after work and before every time you transport the
tool. This minimises the risk of injury.
Secure the Multi-Purpose Air Tool firmly against any move-
ment when transporting it in or on a vehicle (danger of
tipping or sliding).

15. Troubleshooting

Problem
Compressed air device does
not start or lacks power
Tool no longer latches into the
tool receiver or does not lock
into place
Tool cannot be inserted or
removed
Device operates continuously
without the trigger lever being
actuated

Service information

Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also
required for use as consumables.
Wear parts*: Tool inserts
* Not necessarily included in the scope of delivery!
18 GB/IE

Possible Cause

Piston jammed (rusted) in the housing
due to a lack of oil
Dirt has penetrated via the air hose
Too much lubricating oil used or water
in the striking mechanism
Output power of the air source too low Use an air source with a higher output ower
Tool or tool receiver worn out.
Dirt in the sliding sleeve prevents
unlocking
Valve defective

14. Disposal and recycling

The unit is supplied in packaging to prevent its being dam-
aged in transit. This packaging is raw material and can there-
fore be reused or can be returned to the raw material system.
The unit and its accessories are made of various types of mate-
rial, such as metal and plastic. Defective components must be
disposed of as special waste. Ask your dealer or your local
council!
The packaging is wholly composed of environmental-
ly- friendly materials that can be disposed of at a local
recycling centre.
Contact your local refuse disposal authority for more
details of how to dispose of your worn out electrical
devices.
Old devices must not be disposed of with household
waste!
Help
Press the piston back with a striking bolt through the tool re-
ceiver
Introduce a little oil into the connection hose and into the tool
receiver
Run the device briefly without a tool
Repair must be carried out by a specialist workshop
Run the device briefly without a tool
Repair must be carried out by a specialist workshop
Repair must be carried out by a specialist workshop
Repair must be carried out by a specialist workshop