T-Joints; Maintenance And Storage - Parkside PUD 30 A1 Bedienungsanleitung

T-joints

♦ Remove the stop if necessary.
♦ Draw a line on wooden workpiece where you want to attach
wooden workpiece (see Fig. H).
♦ Clamp wooden workpiece at a distance of 35 mm to the marked
line parallel on wooden workpiece (see Fig. H).
♦ Readjust the drilling depth to minus 6 mm of the thickness of
wooden workpiece plus 26 mm for the thickness of the product
itself.
♦ Slide the product with the matching guide groove to the drill
bush over the dowel flush with wooden workpiece (see Fig. H).
♦ Insert the drill into the drill bush and drill a hole (see Fig. H).
♦ Fill the drill holes with wood glue.
♦ Join the two wooden workpieces.

Maintenance and storage

ATTENTION! PROPERTY DAMAGE!
► Do not use aggressive or abrasive cleaning agents, as they can
damage the surfaces of the product.
♦ Use a soft dry brush to remove the sawdust from the product.
♦ You can also clean the product using a dry cloth.
♦ Store the product in a clean, dry location away from direct
sunlight.
│ GB │ IE
■ 8
PUD 30 A1