Before Use; Changing Tools; Torque Preselection/Selecting The Operating Mode; 2-Speed Gearbox - Parkside PNS 300 A1 Originalbetriebsanleitung

Before use

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance .

Changing tools

Your appliance has a fully automatic spindle lock
.
When the motor is stopped, the power train locks
so that the chuck can be opened by turning
it . After you have attached the desired tool
and tightened it by turning the chuck
continue working . The spindle lock is automatically
released when the motor starts (ON/OFF switch
pressed) .
Torque preselection/selecting the
operating mode
You can adjust the torque on the torque selection
ring and select the drill setting .
♦ Select a low level for small screws or soft
materials .
♦ Select a high level for large screws, hard materi-
als or removing screws .
♦ Select the drill setting for drilling work by
adjusting the torque selection ring
position .
■6 │ GB │ IE

2-speed gearbox

CAUTION!
► Operate the speed selector switch
when the appliance is at a standstill . Other-
wise, the appliance could be damaged .
In first gear (speed selector switch
tion: 1)
you can reach a speed of approx . 400 rpm and a
high torque . This setting is suitable for all screwing
jobs .
In second gear (speed selector switch
, you can
position: 2)
you can reach a speed of approx . 1600 rpm for
carrying out drilling work .

Removing the chuck

If you want to use the bit holder
remove the chuck
Removing the chuck:
♦ Hold the chuck
♦ Pull/push the chuck ring
the chuck
The chuck
removed towards the front .
to the
Attaching the quick-release chuck:
♦ To replace the chuck
towards the quick-release chuck and push the
chuck
NOTE
► If the chuck
into place, turn the chuck ring
, you must
.
firmly from the front .
in the direction of
.
is now unlocked and can be
, pull the chuck ring
fully on .
does not automatically click
PNS 300 A1
only
in posi-
in
.