Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig. A) - Parkside PSBSAP 20-Li B2 Originalbetriebsanleitung

Safety guidelines for battery
chargers
This tool may be used by children
■
aged 8 years and above and by
persons with limited physical, sensory
or mental capabilities or lack of ex-
perience and knowledge, provided
that they are under supervision or
have been told how to use the tool
safely and are aware of the poten-
tial risks. Do not allow children to
use the tool as a toy. Cleaning and
user maintenance tasks may not be
carried out by children unless they
are supervised.
To avoid potential risks, damaged
■
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable
for indoor use only.
WARNING!
■ To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person.
ATTENTION!
♦ This charger can only charge the
following batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3.
♦ A current list of battery compatibility can be
found at www.Lidl.de/Akku.
PSBSAP 20-Li B2

Before use

Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the tool before you remove
the battery pack from or connect the battery
pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Connect the battery pack e to the high-speed
charger t (see fig. A).
♦ Insert the power plug into the socket. The green
charge control LED o lights up briefly, then the
red charge control LED i lights up.
♦ The green charge control LED o indicates
that the charging process is complete and the
battery pack e is ready for use.
ATTENTION!
♦ If the red charge control LED i flashes,
this means that the battery pack e has
overheated and cannot be charged.
♦ If the red and green charge control LEDs i/
o both flash, this means that the battery
pack e is defective.
♦ Push the battery pack e back into the tool.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
GB │ MT │ 55 ■