Caution Utility Services; Original Accessories / Attachments; Before First Use; Attaching The Auxiliary Handle - Parkside PSBM 500 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Before first use / First use
J
If the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback.
J
always keep the device clean, dry
and free of oil or grease.
J
Only handle the electrical tool by means
of the insulated handling surfaces when
you are carrying out jobs where the
insertion tool may come into contact
with hidden power supply lines or its
own power cable. Contact with a live elec-
trical wire also makes metal parts of the electrical
tool live and leads to electric shock.
J
Keep your workplace clean and tidy.
Mixing materials is particularly dangerous.
Dust from light metals can burn or explode.
J
Wait until the electrical tool has come
to a standstill before putting it down.
The insertion tool could get caught up in some-
thing and this may lead to control of the electrical
tool being lost.

Caution utility services!

Q
DaNGEr! Ensure that you do not strike
electrical cables, gas or water pipes when
you are working with the electrical power
tool. Check a wall using a suitable detector before
you drill or cut slots.
Original accessories /
Q
attachments
Use only the accessories and attachments
detailed in the operating instructions.
The use of inserted tools or accessories other than
those recommended in the operating instructions
could lead to you suffering an injury.

Before first use

Q
WarNING!
the device off and pull the plug out of the mains
socket before carrying out any work on the device.
10 GB/IE
Downloaded from www.Manualslib.com
DaNGEr OF INJUrY! Switch
manuals search engine

attaching the auxiliary handle

Q
NOTE: For safety reasons this tool must always be
used with the auxiliary handle
j
Turn the wing screw
9
swivel the additional handle
sired position.
j
Then tighten the wing screw

Using the depth stop

Q
j
Open the wing screw
j
Make sure that the toothing on the depth stop
is pointing downwards.
j
Pull the depth stop
8
so that the distance between the tip of the drill
and the tip of the depth stop corresponds to
the desired drilling depth.
j
Firmly tighten the wing screw

Inserting tools

Q
Quick-action drill chuck:
j
Take firm hold of the back casing
quick-action drill chuck
casing until the tool can be inserted.
2
j
Insert the tool.
j
Take firm hold of the back casing
quick-action drill chuck
casing firmly shut.
2
assembly tools for screws and nuts:
j
When using screwdriver bits, always use a
universal bit holder.
j
To screw things in, always switch the changeover
switch "drill / percussion drill"
position .

First use

Q
The mains voltage at the mains socket must match
that shown on the rating plate on the device. Devic-
es marked with 230 V can also be operated at 220 V.
in place.
10
anti-clockwise and
into the de-
10
again.
9
.
9
8
out as far as necessary
.
9
of the
3
and turn the front
1
of the
3
and turn the front
1
to the right to
4