Turning On The Power; Turning Off The Power - Pioneer PDP-503HDE Bedienungsanleitung

Watching TV
Plasma Display
STANDBY/ON
STANDBY/ON
STANDBY/ON
Power indicator
MAIN POWER
Media Receiver
STANDBY/ON
POWER
POWER
Power indicator
Plasma Display status indicators
Off Power off
Flashing red Media Receiver does not turn on or its power cord is disconnected.
Red The Plasma Display System is in standby mode.
Green The Plasma Display System turns the power on.
Media Receiver status indicators
Power off
Off
Only the Media Receiver is in standby mode or the Plasma Display System is in standby mode.
Red
The Plasma Display System turns the power on.
Green
13
PDP-503HDE/(E)-b
INPUT CHANNEL VOLUME
MEDIA RECEIVER
PUSH
PLASMA DISPLAY SYSTEM
0–9
13

Turning on the power

1
Press MAIN POWER on the Plasma Display.
• The power indicator on the Plasma Display flashes red.
2
Press POWER on the Media Receiver.
• The System turns the power on.
• The power indicator on the Plasma Display lights up
green and the one on the Media Receiver lights up in
green.
• If the power indicators still light up red, press any
button from 0 to 9 on the remote control unit or
STANDBY/ON on the Plasma Display to turn the
System on.
PDP-R03E
When turning the Media Receiver on first
1
Press POWER on the Media Receiver.
• The power indicator on the Media Receiver lights up
red.
2
Press MAIN POWER on the Plasma Display.
• The System turns the power on.
• The power indicator on the Plasma Display lights up
green and the one on the Media Receiver lights up in
green.
• If the power indicators still light up red, press any
button from 0 to 9 on the remote control unit or
STANDBY/ON on the Plasma Display to turn the
System on.
A
• "Plasma Display System" and "System" above mean the Plasma
Display Panel and Media Receiver.
• The initial auto installation starts when the System powers on for
the first time. If the System has been turned on before, the initial
auto installation will not be invoked. See page 23 to try auto
installation from the Setup menu.

Turning off the power

1
Press a on the remote control unit or STANDBY/
ON on the Plasma Display.
• The System enters standby mode and the image on
the screen disappears.
• Both power indicators change from green to red.
2
Press MAIN POWER on the Media Receiver.
• The power indicator on the Media Receiver turns off
and the one on the Plasma Display flashes red.
3
Press MAIN POWER on the Plasma Display.
• The power indicator on the Plasma Display turns off
after approximately 5 seconds.
A
• If you are not going to use this System for a long time, be sure to
remove the AC cord from the power outlet.
8/31/02, 5:08 PM