Power Cord Connection; Attaching The Ferrite Cores - Pioneer PDP-60MXE20 Startanleitung

Installation and Connections

Power cord connection

Connect the power cord after all component connections
have been completed.
AC IN
1
1
Connect the power cord to this unit.
2
Plug the power cord into a power outlet.
CAUTION
÷ Use only the power cord provided.
÷ For the Plasma Display, use a three-core power cord with a
ground terminal.
Always be sure to connect the power cord to a three-pronged
grounded outlet and make sure that the cord is properly
grounded. If you use a power source converter plug, use an
outlet with a ground terminal and screw down the ground line.
NO!
Do not use a power supply voltage other than that indicated (AC
100 V to 240 V, 50 Hz/60 Hz) as this may cause fire or electric
shock.
12
En

Attaching the ferrite cores

Power cord (PDP-60MXE20/PDP-50MXE20/PDP-
50MXE20-S)
Attach the accessory ferrite core to the end of the power
cord as shown in the accompanying illustration. Use the
provided cable tie to prevent the ferrite core from slipping
on the cable.
If you do not do this, this monitor will not conform to
mandatory CE or C-Tick standards.
Power cord (PDP-42MXE20)
Attach the accessory ferrite cores to the both connector
ends of the power cord as shown in the accompanying
illustration. Use the provided cable tie to prevent the
ferrite core from slipping on the cable.
2
If you do not do this, this monitor will not conform to
mandatory CE or C-Tick standards.
To power
outlet
Audio cable
Regarding the audio cable, attach the supplied ferrite
core.
Wind the audio cable (not supplied) around the ferrite
core once, and then fasten the catch.
If you do not do this, this monitor will not conform to
mandatory CE or C-Tick standards.
Audio cable (not supplied)
AC power cord
As close as possible
Ferrite core
Ferrite core
Cable tie
To AC IN